Genie GS-2669 IC, Service And Repair Manual

Page: 84 / 171

Service and Repair Manual May 2022
Manifolds
70 GS ™ -2669 RT • GS ™ -3369 RT • GS ™ -4069 RT Part No. 1306516GT
27 Lower the platform and remove the test
weights.
28 Raise the platform approximately 10 feet /
3 m.
29 Lift the safety arm and move it to the center of
the linkage and rotate to a vertical position.
30 Lower the platform onto the safety arm. Push
in the red Emergency Stop button to the off
position.
31 Remove the jumper from the pressure sensor
harness and connect it to the pressure
sensor.
32 Pull out the red Emergency Stop button to the
on position and raise the platform
approximately 10 feet / 3m.
33 Return the safety arm to the stowed position.
34 Lower the platform to the stowed position.
35 Push in the red Emergency Stop button to the
off position.
36 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window.
37 Use the yellow platform down arrow to scroll
to select options.
Result: SELECT OPTIONS is showing in the
diagnostic display window. The ECM is now in
programming mode.
38 Press the lift function enable button.
Result: DESCENT DELAY is showing in the
diagnostic display window.
39 Press the lift function enable button to
deactivate the descent delay option.
40 Use the yellow platform down arrow to scroll
to overload.
Result: OVERLOAD ON is showing in the
diagnostic display window.
41 Press the lift function enable button to
deactivate the overload option.
42 Use the yellow platform down arrow to scroll
to return to the main menu.
Result: RETURN TO MAIN MENU is showing
in the diagnostic display window.
43 Press the lift function enable button.
Result: SELECT OPTIONS is showing in the
diagnostic display window.
44 Push in the ground controls red Emergency
Stop button to the off position.