Genie GS-2669 IC, Service And Repair Manual

Page: 108 / 171

Service and Repair Manual May 2022
Platform Overload Components
94 GS ™ -2669 RT • GS ™ -3369 RT • GS ™ -4069 RT Part No. 1306516GT
15-3
Down Limit Height
How to Cali brat e th e Dow n Limit Heig ht
How to Calibrate the Down Limit
Height
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position
unless otherwise instructed.
Note: The Genie
®
Tech Pro™ Link will be required
to adjust the platform down limit height.
1 Open the ground controls compartment and
locate the level sensor.
2 Start the engine from the ground controls.
3 Push and hold the level to the side until an
audible alarm is heard.
4 Raise the platform until it stops.
5 Push in the red Emergency Stop button to the
off position.
6 Measure the distance between the surface
and the platform floor.
Model Measurement
GS-2669 64 - 76 inches
163 - 193 cm
GS-3369
66 - 78 inches
168 - 198 cm
GS-4069 74 - 86 inches
188 - 218 cm
Result: Platform height is within range.
Adjustment not required.
Result: Platform height is not within range.
Continue with procedure.
7 Connect the Tech Pro Link to the machine.
8 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both ground and platform controls.
9 Go to Settings / Calibration / DLS Percentage.
Increase or decrease the setting between
3.0% - 11%. Repeat this procedure until
platform up stops within the required range.
Note: The default setting is 9.0%.