Genie GS-2669 IC, Service And Repair Manual

Page: 71 / 171

May 2022 Service and Repair Manual
Ground Controls
Part No. 1306516GT GS ™ -2669 RT • GS ™ -3369 RT • GS ™ -4069 RT 57
9 Center a lifting jack under the drive chassis at
the ground controls side of the machine.
10 Raise the machine approximately 4 inches /
10 cm.
11
Models with RT tires
: Place a 1.85 x 10 x
10 inch / 4.7 x 25 x 25 cm thick steel block
under both wheels at the ground controls side
of the machine.
Models with non-marking tires : Place a
1.94 x 10 x 10 inch / 4.93 x 25 x 25 cm thick
steel block under both wheels at the ground
controls side of the machine.
12 Lower the machine onto the blocks.
13 Raise the platform approximately 12 feet /
3,6 m.
Result: The tilt alarm does not sound and all
functions will operate. Proceed to step 15.
Result - The drive function and the lift function
will not operate and the tilt alarm will sound at
180 beeps per minute. Proceed to step 14.
14 Turn the level sensor adjusting nuts just until
the level sensor alarm does not sound.
15 Lower the platform to the stowed position.
16 Raise the machine approximately 4 inches /
10 cm.
17 Remove the blocks from under both wheels.
18 Lower the machine and remove the jack.
19 Center a lifting jack under the drive chassis at
the engine side of the machine.
20 Raise the machine approximately 4 inches /
10 cm.
21
Models with RT tires
: Place a 2.15 x 10 x
10 inch / 5.46 x 25 x 25 cm thick steel block
under both wheels at the ground controls side
of the machine.
Models with non-marking tires
: Place a
2.25 x 10 x 10 inch / 5.72 x 25 x 25 cm thick
steel block under both wheels at the ground
controls side of the machine.
22 Lower the machine onto the blocks.
23 Raise the platform at least 12 feet / 3.6 m.
Result - The drive function and the lift function
will not operate and the tilt alarm will sound at
180 beeps per minute.
Result: If the tilt sensor alarm does not sound,
adjust the tilt level sensor until the alarm just
begins to sound.
24 Lower the platform to the stowed position.
25 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls.
26 Turn the key switch to the off position.
27 Raise the machine approximately 4 inches /
10 cm.
28 Remove the blocks from under both wheels.
29 Lower the machine and remove the jack.