Service Manual
September 2016
Platform
106
AWP Super Series • IWP Super Series
Part No. 38139
12
Remove the lower sprocket housing mounting
fasteners. Do not allow the chain to become
twisted.
13
Remove the upper sprocket housing mounting
fasteners. Do not allow the chain to become
twisted.
14 Rem
ove the fasteners from the outreach
locking bracket.
15
Slide the platform mount off the inner frame
extension arms and set it aside.
16
Locate the two allen head screws in the
platform mount slide pad.
17
Remove the roller from the same side of the
slide pad.
18 Remo
ve the two allen head screws.
19
Remove the master link from the chain.
20
Pull the chain out of the slide pad and both
sprocket housings.
21
Install the new chain through the slidepad.
22
Push the chain through the slide pad until
approximately 2 inches / 5 cm of the chain is
extended past the slide pad.
23
Install the two allen head screws. Install the
roller wheel.
24
Thread the chain through the upper sprocket
housing over the sprocket, then back through
the housing.
25
Thread the chain through the lower sprocket
housing over the sprocket, then back through
the housing. Don't allow the chain to become
twisted.
26
Do not re
-
use the old master link. Install a new
master link.
27
Slide the platform mount onto the extension
arms.
28
Install the outreach locking bracket on the
platform
mount.
29
Install the upper sprocket housing to the
platform mount.
Note: When fasteners are installed, be sure the
center bolt is in between the two chains inside the
housing.
30
Pull the slack out of the chain by pushing
down on the lower sprocket housing.
31
Install the lower sprocket housing fasteners.
32
Adjust the chain. Refer to Repair Procedure,
How to Adjust the Platform Outreach Chain.
33
Install the outreach assembly onto the
carriage.
