SC-ADT Configuration
Configuring SC-ADT for Typical Applications
076R172-000
SpectraComm ADT
3-11
Issue 2
Installation and Operation Manual
Modem Configuration
Any SC-ADT can be configured to use one or two external GDC V.34 modems. When equipped
with internal modems, the SC-ADT can use either the internal or external modems in any
combination. Cabling and configuration are different depending on the type of modem in use. For
online help in configuring external or internal modems, type:
configure modem ?
Figure 3-2
Modem Help Displays
Modem Configuration Procedure
1. Check that the internal and/or external modems are properly connected to the PSTN. If
applicable, check that any external modems are properly connected to Port1 and/or Port 2.
Refer to Chapter 2 under
as needed.
2. Configure each modem interface (required for dial-in networking) by typing:
configure interfaces ip-address modem
[0 or 1]
[###.###.###.###]
[###.###.###.###]
For example:
configure interfaces ip-address modem0 172.16.5.6 255.255.0.0
configure interfaces ip-address modem1 172.16.5.7 255.255.0.0
3. Enter a description for each modem interface by typing:
configure interfaces description modem
[0 or 1]
[your_description]
For example:
configure interfaces description modem0
“NOC Int Modem”
configure interfaces description modem1
“NOC Ext Modem”
4. Enable the modem interfaces by typing:
configure interfaces enable modem0
configure interfaces enable modem1
Note
If your SC-ADT device is not equipped with integral modems and is not attached to compatible external
modems, the modem interfaces will remain disabled.
Summary of Contents for SpectraComm ADT 16-Port
Page 75: ......
