General DataComm SpectraComm ADT 16-Port, Installation & Operation Manual, Page: 68 / 76

Application Guidelines General Application Information
A-4 SpectraComm ADT 076R172-000
Installation and Operation Manual Issue 2
Port inactivity timer Disconnects port session after the
desired interval (in secs) has
elapsed. 0 to 10,000 use 0 to disable
900
Port description Describes the use of the port A quoted string; 72 chars max
(no default)
Port mode Sets the port as a terminal server
or a transport port
Terminal
or Transport
Ports enable/disable Sets admin state ON to allow xmit
and recv
Enable or
Disable
Ports tport Specifies the destination for data
sent from a transport port Local port name (port#)
Remote IP address (a.b.c.d)
Remote port name (port#)
(no defaults)
Ports tel-menu Displays all available terminal
server ports on a telnet session
Enable or
Disable
Escape sequence Escape sequence for connection
of the port
5 chars max,
^^^
SNMP community name Controls access to device
statistics and configuration
community name: 9 chars max,
public
access: read-only (
ro
) or read-write (rw)
status:
Enable
or Disable
Note: A read-only community name allows user to gather statistics from your
ADT, but not change the configuration of the device.
A read-write community name allows user to gather statistics and remotely
configure the device. (The device supports MIB-II system group.)
SNMP traps Sends unit and port information
and alarms to a network controller Destination IP address (a.b.c.d)
Community name: 9 chars max
Status: Enable or
Disable
UDP Port (optional)
162
SNMP system name Assigns a name for the managed
node. Typically is the fully qualified
domain name of the node. A quoted string; 128 chars max
YOUR SYSTEM NAME
SNMP system contact Identifies the contact person for
the managed node adn the
method of contact. A quoted string; 128 chars max
YOUR SYSTEM CONTACT
SNMP system location Describes the physical location of
the node. A quoted string; 128 chars max
YOUR SYSTEM LOCATION
account
(Future Use)
authentication Starts client
authentication for user login via
Telnet or HTTP (web) only
Enable or
Disable
author (Future Use)
attempts Allows a specific number of
attempts to successfully log in to
the device before terminating the
session.
1 to 10 attempts,
3
banner Message banner displayed when a
Telnet login succeeds A quoted string; 72 chars max
(No banner)
Table A-1 Configuration Parameters and Defaults
Configurable Option Description Parameters and Defaults