Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual
page 83 of 87
2. Drag the 7360, 7370 or 7380 off the Stack and place in on the Grid. Press “Confirm
Layout”
3. Then on the Group Define page check the box marked “High Pass analog outputs 85Hz”.
“Confirm Group”
4. On the Calibration Page make all the checks for mic placement and serial number entry.
Double click the mic icon and do the AutoCal calibration for the subwoofer. Confirm
Calibration and
5. Skip
AutoPhase
6. Save the Setup and return to Main Screen
Setting Manual Phase In Hybrid Mode From the Main Page
1. Increase GLM Master Fader to -0dB (Full up)
2. Double click the sub icon. The Acoustic Settings page will appear. Move it to the left or right
of the GLM Main Page.
3. Provide a test signal at the crossover frequency to the subwoofer input.
4. Using the mic SPL reading slowly change
Phase setting
using the < or > keys. We
suggest you start at -180 then click > stopping at -135, -90, -45, 00, +45, +90, +135, +180
and then noting which setting is the loudest SPL on the mic. Do this slowly (about 4
seconds secs) as the mic uses a slow update rate. Then Choose Confirm Settings.
Adjusting level with Mains
It is possible, with significant subwoofer eq bass reduction in AutoCal (see acoustic traces above),
that the Main speakers may need attenuation in order to level match the compensated sub. This
may require a bit of experimentation and can be confirmed by Bypassing the Bass Manager 85Hz
filter as well as adjusting the sensitivity on the main monitor inputs. Press the Subwoofer Bypass
button On, then Off to make this comparison.