Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual
page 82 of 87
subwoofer. Set and store ISS settings with the other group settings from ’Store Group Settings’
page clicking ’Group : Store Group Settings’ menu command.
Notes:
GLM network communication and AES/EBU digital audio clock will wake up / keep active
the SAM monitor or subwoofer.
Some older SAM models won’t support ISS (8240, 8250, 8260, 1238CF, 7260, SE7260,
7270, 7271) and some models requires a firmware update (8351, 12xx with version ‘xxxx x
xxxx 0152 xxxx’ or older).
11.10
What is the “Not used in this setup” bin in the Layout page?
This bin, or box, is typically used to place unused 8130 channels when defining the number of
monitors connected to a SE7261 subwoofer. For example, if 2 x 8130 are connected to input /
output #1 on the SE7261, 8130 monitor channels 1A and 1B will come off the Stack and be placed
onto the Layout Grid. The unused monitor channels 2A thru 4B (total of 6) should be dragged into
the ‘Not used in this setup’ bin.
11.11
How I replace a monitor with a new one?
To replace the monitor or subwoofer with a new one click ‘Setup : Edit Layout’ menu command.
This will open the Layout page. The monitor or subwoofer to be replaced is grayed out on the grid
and a new one is in the Stack. Drag the new monitor or subwoofer and drop it over the old monitor
or subwoofer. Devices are swapped and the old monitor or subwoofer is placed into the Stack.
Drag the old monitor or subwoofer to the ‘Not used in this setup’ bin and click ‘Confirm Layout’
button. Replacement is done and the system can be used normally.
The replacement will copy all settings from the old one to the new one if models are matching.
Otherwise recalibration required.
11.12
How I edit the System Layout?
To edit the System layout click ‘Setup : Edit Layout’ menu command. This will open the Layout
page. Move monitor and subwoofer icons as desired and click ‘Confirm Layout’ button.
Replacement is done and the system can be used normally.
11.13
Can I use 73xx subwoofers with non-SAM monitors?
With GLM, the 7360, 7370 and 7380 subwoofers can be used under the control and calibration
available with GLM and AutoCal with non-SAM monitors.
Since the 7360, 7370 and 7380 have the built-in 85Hz analog HP filters that are regularly available
in Manual mode using the panel dip switches, there is a feature in GLM that enables the 85Hz High
Pass outputs and AutoCal filters as well as phase control available for optimization.
Making New Setup with GLM
1. Launch GLM and make File>New
