Gehl Z17 GEN:2, Operator'S Manual

Page: 60 / 208

13. Operating Instructions
2-20
13-1-2. Checking before start-up
Check the following points before initial start-up for the day.
„
Checking and replenishing the cooling water
1) Open the engine hood. Then check whether the cooling
water level in the sub-tank (1) (illustrated in the figure at
the right) is between the FULL and LOW marks. If the
water level is below the LOW mark, refill the sub-tank up
to the FULL mark through the water supply port of the
sub-tank (1).
For the cooling water to be used, refer to Section "21.
Fueling, Oiling and Greasing Based on Temperature
Range".
2) After replenishing, securely tighten the cap.
3) If the sub-tank is empty, check it for water leakage, and
then, check the water level in the radiator.
If the water level is low, refill the radiator first, then refill
the sub-tank (1).
4) If the cooling water level is proper, close the engine
hood.
• Normally do not open the radiator cap.
• Check the cooling water level in the sub-tank
when the engine is cool.
LOW
FULL
(1)
020174-00X
Courtesy of Machine.Market