Gehl Z17 GEN:2, Operator'S Manual

Page: 44 / 208

2-4
12. Description of Control Devices
This section describes several of the control devices necessary to operate the machine. In order to en-
sure safety and comfort in working with the machine, it is imperative for you to fully understand how to
operate and interact with these devices.
IMPORTANT
For start-up inspection, be sure to refer to PART
THREE: MAINTENANCE, or Section "13. Operating In-
structions" as well as the monitor messages as shown
above.
When the starter switch key is in the “ON” position, the
monitor lamps (3), (4) and (5) light and buzzer sounds.
(Only the water temp alarm lamp (5) goes off in a few sec-
onds.)
Normally, all monitor lamps go off after the engine starts.
When there is any failure during operation, a lamp lights
and buzzer sounds. (If the starter switch key is in the “ON”
position and a monitor lamp does not light, its bulb must be
burnt out.)
12-1. Monitor
When an indicator lamp lights and a buzzer sounds
during operation, immediately stop operation and
check and service the abnormality.
(1)
(2) (3) (4) (5) (6)
(7) (8)
022509-00X
Courtesy of Machine.Market