gefran AFE200 4 Series, Instruction Manual, Page: 145 / 214

AFE200 • Instruction Manual
145
Setting of the time within which the Undervoltage [2] alarm must be reset in order to
perform automatic restart. (Time with alarm signal 100 msec).
Menu PAR Description UM Type FB BIT Def Min Max Acc
15.29 4650 UVRep attempts UINT16 5 0 1000 ERW
Setting of the maximum number of attempts at automatic restart after the Undervolt-
age [2]
alarm before a
Mult Undervoltage [6]
alarm is generated. If this parameter
is set to 1000 an infinite number of attempts are available.
Menu PAR Description UM Type FB BIT Def Min Max Acc
15.30 4652 UVRep delay s UINT16 240 0 300 ERW
Setting of the time within which, if no automatic restarts are executed after the
Und-
ervoltage [2] alarm, the attempts counter is reset. In this way the number of attempts
set in UVRep attempt are still available.
Menu PAR Description UM Type FB BIT Def Min Max Acc
15.31 4670 Optionbus activity ENUM Disable 0 2 ERW
Setting of the behaviour of the AFE product in case of an Opt Bus Fault [16] alarm .
0 Ignore
1 Warning
2 Disable
Menu PAR Description UM Type FB BIT Def Min Max Acc
15.32 4690 ExtIO activity ENUM Disable 0 2 ERW
This parameter is used to configure the behaviour of the drive if the “ Ext I/O fault ” [27]
alarm occurs when the EXP-FL-XCAN-ADV card is installed.
See Chapter 9 - “ Ext I/O fault ” [27] alarm.
When the alarm is activated due to a communication error, the last value that was
received is maintained.
The following activities are programmable:
0 Ignore
1 Warning
2
Disable
You can check whether a card that supports XCAN External IO functions is installed
from the DRIVE INFO menu for parameters 530, 532, 534 SlotX card type:
Value Description Expansion
832 IO FastLink EXP-FL-XCAN-ADV XCAN External IO supported
Menu PAR Description UM Type FB BIT Def Min Max Acc
15.33 4940 FL fault activity ENUM Disable 0 2 ERW
This parameter is used to configure the behaviour of the drive when the “ FastLink
fault
” [28] alarm occurs.
If the EXP-FL-XCAN-ADV card is installed in the drive, all the FastLink communica -
tion fault signals are enabled and managed via generation of a “ FastLink fault ” [28]
alarm, with different subcodes to indicate the cause of the error.
See Chapter 9 - “ FastLink Fault ” [28] alarm.