GEA T.VIS M-20 FDD, Operating Instruction

Page: 15 / 58

Signs on the control top
Sign Meaning
Fig.1
General hazard warning
Fig.2
Warning Crushing
2.9 Residual dangers
Dangerous situations can be avoided by safety-conscious and proactive
behaviour of the personnel and by wearing personal protective equipment.
Residual dangers on the control top and measures
Danger Cause Measure
Danger to life Inadvertent switch-on of the
control top Effectively disconnect all components, effectively prevent switch-
on.
Electric power Observe the following safety rules:
1. Isolate from the power supply.
2. Take appropriate measures to prevent switch on.
3. Test absence of voltage.
4. Earthing and short-circuiting.
5. Cover or safeguard any adjacent live parts.
Damage to property Welding can cause damage to
the electronics or result in data
loss.
Do not carry out any welding work in the vicinity of the control top
or make sure electronics are properly protected.
2.9.1 Electrostatically Endangered Components and Modules
The control top contains electronic components that are sensitive to electrostatic
discharge (ESD). Contact with electrostatically-charged persons or objects can
endanger these components. In the worst case they are destroyed immediately
or fail after being put into operation.
To minimize or prevent the possibility of damage resulting from sudden
electrostatic discharge,
• observe the requirements of DIN EN 61340-5-1 and 5-2,
• be careful not to touch the electronic components,
•
also take care not to touch electronic components when supply voltage is
present.
Use ESD-compliant packaging when returning electronic components. (Contact
GEA Tuchenhagen if you have any questions.)
Safety
Residual dangers
430BAL014475EN_2
03.09.2021 15