•
Insert the journal (8.1) on the pneumatic block into the groove of the base (5)!
Fig.21
Pneumatic block (8.2) for max. 1 solenoid valve
Carry out the following steps:
1.
Fit the pneumatic block in the reverse order.
!
Pneumatic block (8.2): First tighten screw (57.1), then screws (57.2):
tightening torque 1.5 Nm (1.0 lbft).
2.
For fitting the other mounting parts (sensor module, solenoid valve or valve
plate).
®
Done
10.6.7 Install pneumatic connections
Fig.22
No.
Designation
Tightening torques
6
Screw-in plug connection
2.0 Nm
21
Sound absorber
2.0 Nm
Maintenance
Dismantling the Control Top into its Components
430BAL014475EN_2
48
03.09.2021
Summary of Contents for T.VIS M-20 FDD
Page 57: ...Appendix 430BAL014475EN_2 03 09 2021 57...
Page 58: ......
