3.
Grip the sensor module (43) by the mountain bracket and take out of the base
(5). Ensure ESD-compliant handling.
®
Done
Hint!
Fit the sensor module in the reverse order. Observe the wiring
diagrams, see Page 18
10.6.5 Removing the pneumatic block
Requirement:
•
If only O-rings (42) and (55) are to be changed, solenoid valves (63) / valve
plate (65) can remain on the pneumatic block (8).
Carry out the following steps:
1.
Undo the screws (57.1, 57.2).
Fig.20
2.
Pull off the pneumatic block (8).
3.
Change the 6 O-rings (42) of the base (5).
4.
Replace the O-ring (55).
®
Done
10.6.6 Fitting the Pneumatic Block
Requirement:
•
When fitting the pneumatic block, make sure that it is compatible!
Maintenance
Dismantling the Control Top into its Components
430BAL014475EN_2
03.09.2021
47
Summary of Contents for T.VIS M-20 FDD
Page 57: ...Appendix 430BAL014475EN_2 03 09 2021 57...
Page 58: ......
