GE Voluson 730Pro, Service Manual

Page: 128 / 332

GE M
EDICAL
S
YSTEMS
- K
RETZTECHNIK
RAFT V
OLUSON
® 730P
RO
/ 730P
RO
V (BT´04)
D
IRECTION
KTI105947, R
EVISION
2 S
ERVICE
M
ANUAL
4-28 Section 4-4 - Functional Checks
4-4-11 Using the MOD (Magneto-Optical Drive)
The optional 3.5 inch Magneto-Optical disk drive supports the following medias:
1.3GB; 640MB; 540MB; 230MB and 128MB
1.) Before installing an MO disk in the MOD, check the MO disk for loose hardware or damaged labels
which could jam inside the MOD. Also, ensure that the slide switch in one corner of the disk is set
so that the disk is write enabled (disk hole closed).
2.) Insert the disk into the MOD with the label facing up.
3.) There are different methods to eject a disk from the MOD. Manual ejection methods are listed below
in preferred order from best (1) to worst (3).
a.) Press the EJECT switch on the MOD while system is ON.
b.) Press and hold the EJECT switch while the system is booting.
c.) Mechanical ejection. Insert the end of a paper clip into the hole next to the EJECT switch while
system power is OFF.
NOTICE
The MOD (Magneto-Optical Drive) is an Option.
Figure 4-16 Magneto-Optical Drive
NOTICE
Never move the unit with a disk in the MOD because the drive actuator will not be locked and
the MOD could break.
NOTICE
Avoid mechanical ejection whenever possible. Mechanical ejection leaves the actuator
unlocked and the MOD susceptible to damage if moved. If forced to use this method, reboot
the system, then insert and eject a known good disk using one of the other manual ejection
methods.
Eject Button
Magneto-Optical Drive
(MOD)