GE Vivid 4 BT03 RFI, Service Manual

Page: 465 / 594

GE M
EDICAL
S
YSTEMS
D
IRECTION
2392751-100, R
EVISION
3 V
IVID
™ 4 S
ERVICE
M
ANUAL
8-82 Section 8-5 - Back End Parts Replacement
6.) Disconnect all the cables at the rear of the hard disk.
7.) Remove the hard disk.
8-5-16-4 Hard Disk Installation Procedure
Note: Before installing a new hard disk, make sure the jumper settings are as shown below:
1) Place the new hard disk in position in the hard disk module holder.
2.) Reconnect all the cables at the rear of the hard disk.
3) Fasten each of the four screws (two on each side), as shown in Figure 8-67 on page 8-82.
4) Carefully slide the module holder into position in the unit.
5) Return and fasten the screw that holds the hard disk module in position (as shown in Figure 8-56
on page 8-73
Figure 8-67 Hard Disk Removal 2