Your control will allow you to lock out the touch
pads and the cooktop so they cannot be activated
when touched.
To lock/unlock the controls and cooktop:
Touch and hold the
CONTROL LOCK
pad for 3 seconds.
The oven display will show “
Oven
controls and burners locked
” for
several seconds, then “
Range
Locked
.”
To unlock the control, touch and
hold
CONTROL LOCK
for 3 seconds.
■
The
CONTROL LOCK
mode affects all
touch pads. No touch pads will work when
this feature is activated.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
17
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
On some models,
touch the
TIMER/CLOCK
pad and hold for
3 seconds.
On other models,
touch the
CLOCK
pad.
Touch the number pads.
Touch the
START
pad.
To Set the Kitchen Timer
Touch the
TIMER/CLOCK
or
TIMER
pad (depending on model).
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch
2, 4
and
5
in that order. If you make a
mistake touch the
TIMER/CLOCK
or
TIMER
pad (depending on model)
and begin again.
Touch the
START
pad.
After touching the
START
pad,
SET
disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the Kitchen Timer reaches
:00
,
the control will beep 3 times followed
by one beep every 6 seconds until
the
TIMER/CLOCK
or
TIMER
pad
(depending on model) is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The Kitchen Timer is in hours and
minutes.
The Kitchen Timer does not control
oven operations. The maximum
setting on the Kitchen Timer is
9 hours and 59 minutes.
To Reset the Kitchen Timer
If the display is still showing the
time remaining, you may change it by
touching the
TIMER/CLOCK
or
TIMER
pad
(depending on model), then touch the
number pads until the time you want
appears in the display.
If the remaining time is not in the
display (clock, delay start or cooking
time are in the display), recall the
remaining time by touching the
TIMER/CLOCK
or
TIMER
pad (depending
on model) and then touching the
number pads to enter the new
time you want.
To Cancel the Kitchen Timer
Touch the
TIMER/CLOCK
or
TIMER
pad
(depending on model) twice.
Control Lock
(on some models)
Using the clock, kitchen timer and control lock.
www.GEAppliances.ca
(on some models)
(on some models)
Make sure the clock is set to the
correct time of day.
(on some models)
(on some models)
Summary of Contents for PCB975
Page 48: ...48 ...
