GE PACSystems RX7i, User Manual

Page: 269 / 276

Appendix A. Configuring Advanced User Parameters
256 PACSystems* RX7i & RX3i TCP/IP Ethernet Communications User Manual GFK-2224Q
gnostale When bit zero in the “Production Status” field of the
PDU of a consumed sample is set, sample is stale.
0 = allow status to be sent to the application when
exchange status indicates stale data.
1 = prevent the new status from being sent to the
application if exchange status indicates stale data.
0 (0H) 0, 1
EGD provides a UDP port parameter and host group IP address parameter for each of 32 possible host groups
(1-32). The parameter formats for each host group are shown below. XX specifies host group 1-32.
gXX_udp UDP port for host group XX 18246 (4746H) 1 – 65535 (ffffH)
Only the gdata_port
and gXX_udp
parameters may share
the same UDP port
number. All other UDP
port number
parameters in the AUP
file must use unique
port numbers.
gXX_addr Multicast host group IP Address (must be Class D
address)
224.0.7.XX 224.0.0.2 –
239.255.255.255
gXX_ttl IP time-to-live for host group (multicast) messages
(hop count)
1 (1H) 0 – 255 (00ffH)
Note: If you configure different values for EGD exchanges with Unicast and Broadcast destination types, the
largest value will be used for all Unicast and Broadcast exchanges.
If you configure multiple gXX_ttl values for different Multicast exchanges, the smallest value among
the configured parameters will be used for all exchanges.
This applies only to PACS Ethernet Interface modules.
SRTP Client (Channels) Parameters (task h) Default Range
hconn_tout
TCP Connect timeout (in milliseconds) 75000 (124F8H) 10 – 75000 (124F8H)
IP Parameters (task i) Default Range
Ittl
26
IP header default time–to–live (hop count) 64 (0040H) 0 – 255 (00ffH)
ifrag_tmr
26
IP fragment timeout interval in seconds 3 (0003H) 0 – 65535 (ffffH)
ICMP/IGMP Parameters (task j)
None None