GE PACSystems RX7i, User Manual

Page: 268 / 276

Appendix A. Configuring Advanced User Parameters
GFK-2224Q January 2017 255
ARP Parameters (task f) Default Range
fflush
Interval in seconds at which to flush the ARP cache
600 (10 minutes) 0 – 604800 (93A80H)
Ethernet Global Data Parameters
27
(task g) Default Range
gctl_port UDP port for EGD control messages 7937 (1f01H) 1 – 65535 (ffffH)
Only the gdata_port
and gXX_udp
parameters may
share the same UDP
port number. All other
UDP port number
parameters in the AUP
file must use unique
port numbers.
gdata_port UDP port for point-to-point (unicast) EGD messages 18246 (4746H) 1 – 65535 (ffffH)
Only the gdata_port
and gXX_udp
parameters may
share the same UDP
port number. All other
UDP port number
parameters in the AUP
file must use unique
port numbers.
gbcast_ttl IP time-to-live for global broadcast messages (hop
count)
1 (1H) 0 – 255 (00ffH)
gucast_ttl IP time-to-live for point-to-point (unicast) messages
(hop count)
16 (10H) 0 – 255 (00ffH)
gp_phase Startup delay time in ms for successive produced
exchanges
0 (0H) 0 – 65535 (ffffH)
gcmd_pri EGD command processing priority relative to data
production.
0 = EGD commands have lower priority.
1 = EGD commands have equal priority.
2 = EGD commands have higher priority.
0 (0H) 0, 1, 2
gc_accel Enable consumed exchange acceleration.
0= Acceleration disabled; 1= Acceleration enabled. 1 (1H) 0, 1
27
Effective with RX3i CPE310/CPE305 Firmware Release 8.30, all EGD commands are supported except
gcmd_pri and gc_accel.