GE CGA 351, User Manual

Page: 65 / 133

December 2004
4-26 Setup and Calibration
Setting Up the Serial Port
To set up the serial port, enter the User Program , as described on
page 4-1, and proceed as follows:
Note:
The
[Lock All]
and
[Versions]
options are also available.
Entering the Node ID
At the following prompt, choose one of the following numbers as the
Node ID:
16, 32, 48, 64, 80, 96, 112, 128, 144, 160, 176, 192,
208, 224, or 240.
Entering the Baud Rate
At the following prompt, choose one of the following values as the
serial port baud rate:
300, 1200, 2400, 9600, 19200, 38400,
57600, or 115200 .
Cfg Cal Opt Disp Use the [ ] and [ ] keys to
select
[Opt]
. Then, Use the [ ]
and [ ] keys to select
[User]
and press
[ENTER]
.
User
Setup
Lock Menus
POWER ESC ENTER
User Use the [ ] and [ ] keys to
select
[Comm]
and press
[ENTER]
.
Note:
The
[Fault Alarm]
and
[Analog Output]
options are
also available in this list box.
Contrast
Backlight
Comm
POWER ESC ENTER
User Node-ID Use the [ ] and [ ] keys to
scroll the list of available node
ID numbers. When the desired
number is highlighted, press
[ENTER]
.
Node ID
s
16 t
POWER ESC ENTER
User Node..Baud-Rate Use the [ ] and [ ] keys to
scroll the list of available baud
rates. When the desired rate is
highlighted, press
[ENTER]
.
300
1200
2400
POWER ESC ENTER
www.DataSheet4U.com
www.DataSheet4U.com