GE CGA 351, User Manual

Page: 58 / 133

Setup and Calibration 4-19
December 2004
Setting the Zero Setpoint
Enter the analog output setup menu, as described on page 4-16, and
proceed as follows:
Note:
The
[Test], [Zero Trim]
and
[Span Trim]
options are also
available in the above list box.
At the next prompt, enter the desired zero setpoint.
The meter now automatically returns to the “Analog Output” prompt.
Either press
[ESC]
until you exit the User Program or proceed to the
appropriate section to continue setting up the analog output.
User Aout Use the [ ] and [ ] keys to
select
[Zero Setpoint]
, and press
[ENTER]
Aout Type
Zero Setpoint
Span Setpoint
POWER ESC ENTER
User Aout Zero-Set Use [ ] and [ ] to position the
cursor under the desired char-
acter. Then, use [
] and [ ]
to increment the value. Press
[ENTER]
when done.
ppm
000.00
s
POWER ESC ENTER
www.DataSheet4U.com
www.DataSheet4U.com