DU-LC-0002-60 Rev C 6/14/06 GCX Corp. Page 2 of 11
5/16-18 x 1'' HHCS
5/16 Flat Washer
5/16 Lock Washer
1.0 Assembling the Roll Stand with Counterweight and Utility Basket
Parts Reference
The following parts and hardware are provided for this procedure:
Tools Required
Phillips screwdriver (not provided), 1/2'' wrench (not provided).
1. Attach two (2) Nylon Basket Clips to Wire Utility Basket in accordance with separate installation guide (
DU-UT-0002).
Insert two (2) #8-32 x 1-1/2'' PHMS and #8-32 hex nuts in Basket Clips but do not tighten at this time.
2. Slide Basket Clips over bottom end of Roll Stand Post and insert Post in center of Roll Stand Base (below left). Lay
assembly on its side.
3. Using a 1/2'' [13mm] wrench, fasten Post to Base using one (1) 5/16-18 x 1'' HHCS, with 5/16 lock washer, and 5/16
flat washer (below right).
4. Slide Basket to desired mounting position on Post and tighten two (2) Basket Clip screws to secure Basket.
Item #
Description
Qty
1
Post, 44'' with 6'' Offset
1
2 Base
1
3
5/16-18 x 1'' Hex Head Cap Screw (HHCS)
1
4
5/16 Split Lock Washer
1
5
Roll Stand Washer, 2''
1
6
Utility Basket, 6''
1
7
Nylon Basket Clip – Utility Basket Attachment
2
8
#8-32 x 1-1/2'' Pan Head Machine Screw (PHMS)
2
9
#8-32 x Hex Nut
2
Basket Clips (2)
#8-32 x 1-1/2'' PHMS (2)
#8-32 Hex Nuts (2)
1
Base
Post
6
7
2
