Installation manual for wall mounting for flat screen.
EPB64FW
Note: t is recommended that this product be installed only by a professional. We do not accept
responsibility for damages caused by improper installation, assembly or use of this equipment.
In case of any doubt, please contact a professional to help you.
IMPORTANT.
•
For safety reasons, the wall or mounting surface must be able to support the
combined weight of the mounting and the screen; otherwise the structure must
be reinforced.
•
Appropriate safety equipment and tool must be used. Failure to do so may result in
property damage or serious injury.
•
Make sure electrical wires, water pipes or gas pipes are not located between the wall.
Tools required for installation
•
Screwdriver cross head.
•
Electric or portable drill.
•
1/8”(3 mm) Drill Bit + Post Detector (installation in plaster wall)
•
7/16”(11mm) Concrete drill bit (concrete installation)
Make sure all installation accessories are included with the assembly. Included:
Wall Installation
(A) M6x50 Delay Bolt
(E) M6x30 Bolt
(D) M6x12 Bolt
(G) M8x12 Bolt
(C) Washer
(F) Long spacer
(H) M8x30 Bolt
(B) Concrete anchor
(I) M6 washer
Plaster Wall
Concrete Wall
Pole
Pole detector
Measuring tape
Measuring tape
Use a pencil to mark the holes
Use a pencil to mark the holes
Insert a concrete anchor in each hole
Place the mounting rail on the wall,
fixing it with bolts (A) and washer (C).
Place the mounting rail on the wall,
fixing it with bolts (A) and washer (C).
Select the appropriate bolts for the
installation, in case of using a long bolt,
the spacer will also be necessary.
Do not use the M6 washer, if using the M8
bolt
