![background image](http://html.mh-extra.com/html/gbc/arctic-titan-165/arctic-titan-165_instruction-manual_570922026.webp)
Parts changing
Titan 165/ 110 Technical Service Manual
Page 3 - 4
© GBC Films Group October 2000
3.2 Heaters
W A R N IN G
D o n ot perform this procedure un less
the h eaters have rem ain ed off for a
m inim um of 4 hours.
Tools required
• 8 mm wrench
• 1 pair safety gloves
• #2 phillips screw driver
3.2.1 Removing the heater(s)
a) Remove all power to the laminator.
b) Remove the cabinets as described in Section
3.1.1.
c) Remove the nut securing the heater wire to the
end of the heater being removed using an 8 mm
wrench. Do this for both sides.
d) Use the 8 mm wrench to remove the nut
securing the heater to the heater support plate.
Do this for both sides.
e) On the control side only: ( upper ) Remove the
two phillips head screws securing the heater
bracket to the heater support arm. ( lower )
Remove the two phillips head screws securing
the heater support arm from side frame.
C A U T IO N
A lw ays w ear safety gloves w hen
hand ling glass quartz heaters.
f) Carefully slide the heater out from the control
side.