Parts changing
Titan 165/ 110 Technical Service Manual
Page 3 - 2
© GBC Films Group October 2000
3.1.1 Remove the cabinets
Tools required
• 3 mm allen wrench
• 2.5 mm allen wrench
• Small flat tip screw driver
• #2 phillips head screw driver
• Second person
a) Use the 3 mm allen wrench to remove the lift
handle on the control side cabinet.
b) Use the 2.5 mm allen wrench to loosen the two
set screws on each on the tension handles on
the control side.
c) While the second person is holding the control
side cabinet, remove the six screws securing the
cabinet to the frame with a #2 phillips screw
driver.
d) Disconnect the contact block to the emergency
stop push button using a flat tip screw driver
and set the control side cabinet in a safe place.
e) Disconnect the control panel cable from the
back of the control panel circuit board.
C A U T IO N
D o n ot pull on the w ire in attem pt
to disconnect the cable!
f) While the second person is holding the drive
side cabinet, remove the six screws securing the
cabinet to the frame with a #2 phillips screw
driver.
g) Disconnect the contact block from the emergency
stop push button using the flat tip screw driver
and set the drive side cabinet in a safe place.
