Page 2 - 5
© GBC Films Group October 2000
Calibrations
Titan 165/ 110 Technical Service Manual
c) With a #2 phillips head screw driver, remove the
drive side cabinet.
d) Use the small flat tip screw driver to remove the
contact block to the emergency stop buttons.
e) Adjust the nut on the end of the clutch assembly
as needed to achieve satisfactory output quality.
( To increase clutch, loosen / tighten to decrease )
C lutch
ad ju stm en t
f) When finished, replacethe drive side cabinet.
2.4 Temperature calibration
This calibration adjusts the temp displays
to properly reflect the heater temperatures.
Tools required
• Small flat tip screw driver
• 2.5 mm allen wrench
• 3 mm allen wrench
• # 2 phillips screwdriver
• Small flat tip screwdriver
• GMP Heat Calibration Box
a) With a 3 mm allen wrench, remove the lift handle
from the control side cabinet.
b) With a 2.5 mm allen wrench, remove the upper
and lower unwind brake handles.
c) With a #2 phillips head screw driver, remove the
control side cabinet.
