![background image](http://html.mh-extra.com/html/gbc/arctic-titan-165/arctic-titan-165_instruction-manual_570922017.webp)
Page 2 - 1
© GBC Films Group October 2000
Calibrations
Titan 165/ 110 Technical Service Manual
2.0 Calibrations
W A R N IN G
D o n ot w ear ties, loose fit clothing or
dangling jew elry w hile operating or
servicing the lam inator. T hese item s can get
caugh t in the n ip and ch oke you or you can
be crushed or burned.
C A U T IO N
O nly the prim ary person ( person
perform ing the calibration ) m ay control th e
functions of th e lam intor during any
calib ration procedure!
Calibrations ensure the optimal performance of
the machine during operation. All procedures in this section
should only be performed by a qualified service technician
( Qualified is described in Section 1 ).
The following procedures are described in this
section; Main roller nip, Pull roller nip, Clutch tensioning
and Temperature calibration.
E L E C T R IC A L
S H O C K
A lw ays exercise extrem e caution w hen
perform ing calibration p rocedures.
C abinets, panels and covers m ust be
rem oved and p ow er to the m achin e is O N .
2.1 Main roller nip
This calibration ensures the main rollers nip is even
from left to right. Main roller nip should be performed at
time of installation.
Tools required
• Two rolls of thermal film ( see film width below )
T110 = 41 in. rolls / T165 = 51 in. rolls
• 2.5 mm allen wrench
• 3 mm allen wrench
• 5 mm allen wrench
• # 2 phillips screwdriver
• Small flat tip screwdriver
C A U T IO N
A lw ays practice lock ou t/ tag out procedures
w hen perform ing service related w ork.
a) Set up he machine as you would for two sided
thermal encapsulation.
b) After webbing the machine, run about 1 ft. of
material through and then stop for about 30
seconds.
c) After aproximately 30 seconds, run the web out
until the nip impression in the laminate exceeds
the pull rollers by 1 ft.