Page 2 - 3
© GBC Films Group October 2000
Calibrations
Titan 165/ 110 Technical Service Manual
2.2 Pull roller nip
This calibration ensures the pull rollers nip is even
from left to right. Pull roller nip should be performed at
time of installation.
Tools required
• Two rolls of thermal film ( see film width below )
T110 = 41 in. rolls / T165 = 51 in. rolls
• 2.5 mm allen wrench
• 3 mm allen wrench
• 5 mm allen wrench
• # 2 phillips screwdriver
• Small flat tip screwdriver
C A U T IO N
A lw ays practice lock ou t/ tag out procedures
w hen perform ing service related w ork.
a) Set up he machine as you would for two sided
thermal encapsulation.
b) After webbing the machine, run the machine while
observing the quality of the output without paper,
then with paper. If the output quality is good,
STOP. If not, continue with the next step.
IN F O R M A T IO N
A n y w aves in th e lam in a te an d / or w aves at
th e m ain roller n ip con stitu te p oo r ou tp u t.
G o od ou ptut
P oo r ou ptut
c) With a 3 mm allen wrench, remove the lift handle
from the control side cabinet.
d) With a 2.5 mm allen wrench, remov ethe upper
and lower unwind brake handles.
e) With a #2 phillips head screw driver, remove
both cabinets.