Chapter 4 – Smoke Control Section, Page 4-36__________________________________________________
Wash System – Troubleshooting (Cont.)
Clogged Spray Nozzle – Cont.
Removing a Standard Manifold.
1.
The Standard Manifolds are connected to the water inlet pipe with a quick disconnect fitting. Slide
the outer couple towards the water inlet and push the manifold away and off to one side (Refer to
Figure 4-36-2).
2.
Slide the manifold out through the Cell/Plumbing Compartment access door.
Figure 4-36-1
Motor Manifold
Figure 4-36-2
Standard Manifold
Square Manifold
Manifold
Extension Pipe
Linkage
Quick Disconnect
Linkage
