Smoke Control – Wash Cycle (Cont.)
The amount of hot water used is dictated by the number of ESP Cells. Refer to Table T-4-7-1 and T-4-7-2 for
the amount of hot water used per 3 minute wash and rinse, and total water used for the entire wash cycle.
Important Note:
The wash, delay and rinse times may be programmed for different times as needed to adequately
clean the ESP Cells. The Command Center illustrated in this manual may not represent the model of
Command Center you have. Refer to the Technical Manual for your specific model of Command
Center for complete instructions on programming wash, delay and rinse cycle times. If you do not
have a Technical Manual for your Command Center, obtain the model number from the nameplate
on the Command Center and contact Gaylord Industries. Refer to page 1-1 for contact information.
