Gateway E-9425R, User Manual

Page: 59 / 128

Replacing the power cage www.gateway.com
53
10
Reinstall the power supply modules by following the instructions in
“Replacing a power supply module” on page 51 .
11
Follow the instructions in “Closing the server case” on page 32 .
Replacing the power cage
To replace the power cage:
1
Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Follow the instructions in “Opening the server case” on page 31 .
3
Remove the power supply modules by following the instructions in
“Replacing a power supply module” on page 51 .
4
Remove the power distribution board by following the instructions in
“Replacing the hot-swap backplanes” on page 54 .
5
Loosen the screws (3) holding the power cage in the chassis.
6
Slide the power cage (4) toward the front of the chassis to disengage the
locking tabs, then lift the power cage out of the chassis.
7
Place the new power cage into the chassis, aligning the cage with the
locking tabs in the chassis, then slide the power cage toward the back of
the chassis to engage the locking tabs.