Gateway E-9425R, User Manual

Page: 41 / 128

Installing and removing drives www.gateway.com
35
9
Slide the new optical drive into the drive bay, making sure you align the
drive with the retaining clips on both sides of the drive.
10
Push the retaining clip against the drive until snug, then tighten the
thumbscrew to hold the drive in place.
11
Connect the 44-pin optical drive cable to the back of the optical drive
interface board.
12
Follow the instructions in “Closing the server case” on page 32 .
13
Reinstall the bezel, if required, by snapping it into place on the front of
the chassis.
14
Reconnect all power cords and peripheral device cables, then turn on the
server.