Gasboy SERIES 1000, Operation Manual

Page: 232 / 241

GASBOY Series 1000
B-4 05/29/03
1. Turn the printer offline by pressing SELECT. The SELECT light should go off.
2.
Position the print head at the top of the paper and press the TOF SET button.
3.
Put the printer back online by pressing SELECT. The SELECT light should go on.
4.
Press the MODE button until the light next to HSD is lit.
5.
Press the PITCH button until the light next to 17 is lit.
NOTE: Pitch may be set to a lower number (resulting in larger print) if transactions are less
than 80 characters.
Veeder-Root TLS-250 or 250I
1. Inside the right hinged cover of the TLS-250, is the Option PCB. Locate the rotary baud rate
switch in the lefthand corner of the PCB. Set the rotary baud switch to position 4 (1200 baud)
or position 6 (300 baud).
2.
On the Parity/Security Code dip switch on the upper lefthand side of the TLS Main PCB, set
the switches as follows: 1, 2, 3, CLOSED; 4 and 5 OPEN. This sets the TLS for even parity
and no security code.
Veeder-Root TLS-350
1. Inside the printer door on the lefthand side of the TLS, locate a four position dip switch
labeled S1. Set position 2 of the switch to OPEN to disable the security code.
2. Following the instructions in your TLS-350 manual, set these parameters to the values
shown:
Baud Rate: 1200 or 300
Parity: EVEN
Stop Bits: 1
Data Bits: 7
Series 1000 Setup
For any of the tank monitors, the setup on the Series 1000 is the same.
1.
On the Auxiliary Communications PCB (This is the small PCB located at the upper right of the
MPU PCB inside the Series 1000 head), locate the K1 jumper patch.
2.
Set the baud rate on position 1 of the K1 jumper patch to match the baud rate being used on
the tank monitor. Do not exceed 1200 baud.
3.
Locate the P2 (RS-232) and P3 (RS-422) connectors on the Auxiliary Communications PCB.
Connect the cable from the tank monitor to either P2 or P3 depending on the type of
communication you are using.