Gasboy SERIES 1000, Operation Manual, Page: 156 / 241

GASBOY Series 1000
19-8 05/29/03
LO - LOAD ODOMETER/HOURS
Use the LO command to update odometer/hours readings for an existing vehicle record. This
command helps to maintain accurate odometer/hours readings (such as in cases where the
selected vehicle may have fueled at another location, etc.)
NOTE: The prompts and procedure steps shown in this section are for L/100KM. If you have the
liters-per-hour option, your prompts will contain HOURS instead of ODOMETER and LPH
instead of L/100. An example of LPH commands is shown at the end of this command
procedure.
1. At
the
*
prompt, type LO. The system displays: VEH. NO.
2.
Type the vehicle number and press RETURN. The system displays: BEGIN ODOM:
3.
Type the vehicle’s present odometer reading and press RETURN.
NOTE: If the vehicle record does not exist, the system displays NO RECORD FOUND!
The VEH. NO. prompt reappears.
4.
To update additional odometer readings, repeat this procedure from Step 2.
To stop updating odometer readings, press RETURN at the VEH. NO. prompt.
The
*
prompt reappears.
NOTE: Both the beginning and ending odometer field are loaded with the kilometers
entry. The liter total field is reset to zero.
Example for L/100KM:
03
:),23
↵
&)+-23(31 ↵
:),23
↵
Example for LPH:
03
:),23
↵
&)+-2,3967 ↵
:),23
↵