Gasboy SERIES 1000, Operation Manual

Page: 226 / 241

GASBOY Series 1000
A-6 05/29/03
LF - Load Fuel
Use the LF command to assign fuel types to the product authorization codes. Authorization codes
are 2-digit codes, encoded on the user’s card, that enable the user to access the fuels assigned to
that code. Before you can assign authorization codes to products, you must make a list of all your
products and assign numeric codes to each. At start-up time, you enter these fuel products into
the system using the LP (Load Pump Data) command. Once you have your fuel products defined,
you can assign them to two-digit authorization codes. You can use the numbers 01-99 to assign
your fuel types. Code 00 is preset to allow all fuel types. Authorization codes do not need to be
sequential, you can use any two digit number in the 01-99 range.
The number of authorization codes and the numbers of fuels is limited to 500. For example, you
can have 100 authorization codes with 5 fuel types assigned to each, or 50 authorization codes
with 10 assigned to each. Whichever combination you choose, the total of codes and fuel
assignments cannot exceed 500.
1. At
the
*
prompt, type LF. The system displays AUTH NO.:
2.
Type an authorization code number from 01 to 99 and press RETURN. The system displays
FUEL CODE:.
3.
Type the 2-digit fuel type and press RETURN.
4.
Repeat Step 3 to continue assigning fuel types to the authorization code.
5.
To stop entering fuel types for this authorization code, press RETURN at the FUEL CODE:
prompt. This displays the next AUTH NO.: prompt.
6.
Repeat this procedure from Step 2 to define fuel types for additional authorization codes.
To stop entering authorization codes, press RETURN at the AUTH NO.: prompt. The
*
prompt reappears.
Example:
0*
%98,23
↵
*9)0'3()
↵
*9)0'3()
↵
*9)0'3()
↵
*9)0'3()
↵
*9)0'3()
↵
%98,23
↵
*9)0'3()
↵
*9)0'3()
↵
*9)0'3() ↵
%98,23 ↵