Gasboy SERIES 1000, Operation Manual, Page: 231 / 241

Setup of Peripheral Equipment
05/29/03 B-3
6. Press F5 or PAGE DOWN to display the next Setup Screen, ANSI Setup.
%27-7IXYT
*/I]0SGO 3JJ 7IRH %PP
*IEXYVI0SGO 3JJ 4VMRX 2EXMSREP
/I]TEH 2YQIVMG 7IRH%VIE 7GVIIR
'YVWSV/I]W 2SVQEP 4VMRX%VIE 7GVIIR
<JIV8IVQ )37 7IRH8IVQ 2SRI
'LEV1SHI 1YPXMREXMSREP 4VMRX8IVQ 2SRI
'LEV7IX ()'1'7 4VMRX1SHI %YXS
/I]W 8]TI[VMXIV %YXS%RW[IVFEGO 3JJ
:8-( :8
7. Press
S to save Setup changes.
8. Press F9 or E to exit Setup Mode.
OKIDATA 184 SETUP
To prepare the Okidata printer for operation with the LINK MC5 terminal and your GASBOY Fuel
Management System, perform the following steps. Install and complete the setup of the printer as
specified in the manufacturer’s setup instructions. Then set up the switches as follows:
SW1
SW1-1 ON
Parity: Odd
SW1-2 ON Parity: Without
SW1-3 ON Data bits: 8
SW1-4 OFF Protocol: XON/XOFF (Series 1000 V8.1 or higher)
ON Ready/Busy (Series 1000 versions prior to V8.1)
SW1-5 ON Test select: Circuit
SW1-6 ON Mode select: Print
SW1-7 ON Busy line selection: DTR - Pin 20
SW1-8 ON Busy line selection: DTR - Pin 20
SW2
Baud
Rate SW2-1 SW2-2 SW2-3
9600 OFF ON ON
2400 OFF OFF ON
1200 ON ON OFF
300 ON OFF OFF
NOTE: Any change made to the baud rate must also be changed on the Link terminal
Communications Setup screen, Aux Baud parameter.
SW2-4 ON
DSR output signal: Active
SW2-5 ON Buffer threshold: 32 bytes
SW2-6 OFF Busy signal timing: 1 sec (min.)
SW2-7 ON DTR signal: Space after power on
SW2-8 OFF Not used