EN
8
Installation Instructions
353116
GLB-T222WO
230/400V 32A 50Hz
IP44 EN 61851-1 IEC61439-7 AEVCS
SN: 5022254
BOX 203, 335 25 GNOSJÖ, SWE
Before installing the Garo GLB-Wallbox, gather the following tools and materials:
• Pen or marker
• Hole punch (optional, to push through cardboard template)
• Wire cutter
• Voltmeter or digital multimeter (to measure AC voltage at the installation site)
• Small flathead screwdriver
• Medium flathead screwdriver
• Large flathead screwdriver (optional, to remove plastic knock-outs on backside of GLB Wallbox)
• T20 Torx driver
• 3 screws (and plugs) suitable for wall type
• Ferrules (the diameter of the ferrule depends on the diameter of the power wiring and the
construction)
• Level
• Power drill
• Twisted pair cable (Optional only when DLM is used) Cable: Suitable for Modbus communication.
• Cable gland for communication cable (Optional only when knock-outs on backside of GLB
Wallbox is used)
Tools and Materials Required
Important Information
The GARO GLB Wallbox is an AC charge-station enabling Mode 3 charging which complies fully
with the requirements of IEC 61851-1 and IEC TS 61439-7. The product complies with IP Code
IP44, with a closed front.
It is to be fitted to a wall or GARO Wallbox stand, and all installation must be carried out by an
authorized installer and comply with local country installation regulations.
(figure 1)
Type Label example
GLB Type
