__________________________________________________________________________
G1000 System Maintenance Manual
Page 6-9
190-00903-00
Rev.
A
6.20 CONFIGURATION
MODULE
Figure 6-2. Configuration Module
To remove:
1.
Remove two screws (item 8) from cover (item 7) and remove cover.
2.
Unplug connector from configuration module (item 1).
3.
Remove configuration module.
To install:
1.
Inspect connector for damaged pins.
2.
Place configuration module (item 1) in position.
3.
Insert connector into configuration module (item 1).
4.
If GRS 77 AHRS configuration module is replaced, proceed to Section 6.6.
5.
If GDC 74 configuration module is replaced, proceed to Section 6.5.
6.
If master configuration module is replaced:
7.
Turn the PFD on in configuration mode (press and hold the ENT key while powering up the
unit).
8.
Go to the configuration upload page in the system page group.
9.
Press the UPDT CFG softkey.
10.
If the PFD and master configuration module are replaced, proceed to Section 9.
If the master configuration module is replaced, the G1000 system ID number will change. The
Terrain, TAWS unlock, Chartview/Jeppview/FlightCharts and other SD cards may need to be
replaced since they will be locked to the old system ID number. Contact Garmin for assistance
in determining which cards will need to be replaced.
