Garmin Beechcraft 200 Series, Cockpit Reference Manual

Page: 40 / 270

Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series 190-02040-01 Rev. B 16
Nav/Com/XPDR/Audio Panel
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Abnormal
Oper
ation
Annun/Alerts
Appendix
Index
3)
Press the
ENT
Key to display the ‘Load Frequency’ Window.
4)
Turn the
FMS
Knob to place the cursor on the desired COM frequency field.
5) Press the ENT Key to load the COM frequency into the selected COM
frequency field.
Changing COM frequency channel spacing:
1)
Select the ‘AUX – System Setup 1’ Page.
2)
Press the
FMS
Knob to activate the flashing cursor.
3)
Turn the large FMS Knob to highlight the Channel Spacing Field in the
COM Configuration Box.
4)
Turn the small FMS Knob to select the desired channel spacing.
5) Press the ENT Key to complete the channel spacing selection.
NAV OPERATION
Manually tuning a NAV frequency:
1) Turn the NAV Knob to tune the desired frequency in the NAV Tuning Box.
2) Press the Frequency Transfer Key to transfer the frequency to the NAV Active
Frequency Field.
3) Adjust the volume level with the NAV VOL/ID Knob
.
4) Press the NAV VOL/ID Knob to turn the Morse code identifier audio on and
off.
Manual NAV frequency tuning from the PFD/MFD Controller
1)
Press the NAV Key to enable the FMS Knob for NAV tuning. The NAV
Tuning Selection Box is shown.
2)
Press the NAV Key again, if needed, to select the desired NAV radio (1 or
2).
3)
Turn the FMS Knob to tune the desired frequency in the NAV Tuning Box
(large knob for MHz; small knob for kHz).
Or
:
Press the numeric keys on the keypad to enter a Frequency.
4) Press the Frequency Transfer Key to transfer the frequency to the active field.