![background image](http://html1.mh-extra.com/html/garland/xpe12/xpe12_installation-operation-and-maintenance-manual_564394032.webp)
32
Part #: GAR_IOM_ 4532522 Rev 08—6/17
Installation
Section 2
8. Beware of the red mark in the threaded stem to
indicated the maximum adjustment. Red mark in the
threaded stem portion should not be visible.
Warning:
Adjusting above the red mark could cause the
caster to fail & the unit to tip.
FRONT CASTER WITH BRAKE
REAR CASTER WITHOUT BRAKE
Red Mark in Shaft
Should
NOT be Visible
Caster Jam Nuts
9. After the grill is completely level, align the caster
wheels straight ahead as shown. Then rotate the locking
pin until is seated fully into the slot and secured. Now,
tighten caster jam nut to secure the caster assembly.
Securing Stabilizer Grill System (1 platen models only)
Stabilizer system will help prevent the grill from tipping-
over within a range of 0
0
to 10
0
degrees angle perpendicular
to the front of the unit.
1. Proceed and complete Caster Adjustment Procedure as
mentioned above.
2. Lower the stabilizing arms, (total of four (4) arms
located beside the side panels) until the arms touch the
floor.
3. Raise each arm 0.25” (6.4mm) off the floor and secure
the arm with the bolt on the side of each arm, as shown
below.
ADJUST TO
Tight bolts to secure arm in place
total of four (4) bolts
Stabilizer Arm
Stabilizer Arm
0.25in
6.4mm
NOTE: UNDER NO CIRCUMSTANCES SHOULD YOU
REMOVE THE STABILIZER SYSTEM FROM GRILL.
Remove Stainless Steel Plastic Film Cover
Removing this film is one of the things that must be done
once the Grill is in place. The film covers both internal and
external components (e.g. side panels, grease shield) and
must be removed before turning the grill on.
1. Using a plastic scraper,
wedge the film away from
the stainless steel.
2. Grasp and pull the film
very gently away from the
stainless steel.
Temporary Storage
Garland provides adequate protection under normal
conditions in transit and storage. The grill may need
additional protection if it is stored near salt water, a tropical
area, or other unfavorable conditions. Please contact
Garland immediately if these conditions occur.
Gas Connector Requirements:
•
Installation shall be made with the gas connector that
has been supplied with the grill or similar approved
connector. The quick disconnect fitting and gas shut
off valve must be installed in the direction indicated on
their outer body.
•
NOTE: When checking gas pressure, be sure that all
other equipment on the same gas line is on.
•
The appliance and its individual shut-off valve must be
disconnected from the gas supply piping system during
any pressure testing of that system pressures in excess
of ½ PSIG (3.45kPa).
•
Adequate clearance must be provided for servicing and
proper operation.
•
A restraining device must be installed when a flexible
gas hose is used.
PEEL OFF PL
ASTIC FILM