41
B. For 3-digit Remote Control Command
The 3-digit Remote Control Command is
used for turning off the Power Switch.
z
Send the SMS message to command
the Unit to turn off the Power Switch #
1, and send a confirmation SMS back
to your mobile phone. The format is:
J
O
E
1 2 3 4 5 1 0 0 0
The programmed
SMS keyword
User PIN
Code
Power
Switch
Number
<
<
N
N
O
O
T
T
E
E
>
>
)
A confirmation SMS message will read
on your mobile phone as:
Confirmation, Joy 1234 510 00
z
Send the SMS message to command
the Unit to turn off the Power Switch #
1 without a confirmation SMS back to
your mobile phone. The format is
J
O
E
1 2 3 4 5 1 0
The programmed
SMS keyword
User PIN
Code
Power
Switch
Number
C. For 5-digit Remote Control Command
z
Send the SMS message to command
the Unit to turn on the Power Switch #
1 for 1 Hour and than turn off, and
send a confirmation SMS back to your
mobile phone. The format is:
J
O
Y
1 2 3 4 5 1 1 0 1 0 0
programmed
SMS keyword
PIN
Code
Power
Switch
Number
Time
<
<
N
N
O
O
T
T
E
E
>
>
)
A confirmation SMS message will read
on your mobile phone as:
Confirmed, Joy 1234 51101 00
z
Send the SMS message to command
the Unit to turn on the Power Switch #
1 for 1 Hour and than turn off without a
confirmation SMS back to your mobile
phone. The format is:
J
O
Y
1 2 3 4 5 1 1 0 1
The programmed
SMS keyword
User PIN
Code
Power
Switch
Number
Time
<
<
N
N
O
O
T
T
E
E
>
>
)
The system will automatically filter
through all incoming SMS messages
for SMS Keyword and automatically
ignores and deletes SMS which does
not contain the SMS keyword. For all
authorized Remote Command that
comes with proper keyword and PIN
code, the system will immediately
carry out the contained command(s)
and delete the SMS message
afterward.
3.14. Dialling & Call
Acknowledgment
3.14.1. Auto Dialing
z
If the system is in Arm mode, when an
alarm occurs, the Control Panel will
immediately dial the phone numbers you
preset and play the recorded messages.
z
If the system is in Home mode or
Disarmed mode, when an audible alarm
is initiated, the Control Panel will wait 15
seconds and then dial the phone
numbers.
z
After dialing, the Control Panel will delay
5 seconds then starts to play the
message. It firstly played the general part
of the recorded message (address) then
plays the specific alarm message (Burglar,
Fire, Medical or Panic) depending on the
nature of the alarm.
z
To ensure the call is successfully received
by the recipient, the recipient should
acknowledge the message by pressing
the appropriate button on his telephone
set.
Summary of Contents for CTC-1132
Page 1: ...Installation Programming Operating D D 29 APR 2009...
Page 2: ......