Gardsman CTC-1132, Installation & Operating Manual

Page: 15 / 48

11
To Delete Temp. Code
After the Temp. Code is programmed, it can be
deleted by following the steps below:
Step 1 . Move the cursor to the item Temp.
Code then press OK key.
D e l e t e
P i n - C o d e ( + O k )
Step 2 . Press OK key and the screen returns
to Gen. Settings Menu
To Edit Temp. Code
After the Temp. Code is programmed, it can be
edited by following the steps below:
Step 1 . Move the cursor to the item Temp.
Code then press OK key.
D e l e t e
P i n - C o d e ( + O k )
Step 2. Press key, the next screen will ask
you to enter your new Temp. code and
repeat it for double confirmation.
Step 3 . Make your selection whether to have
the Latch Key Reporting or not press
OK key. The screen returns to
General Setting menu, editing the
Temporary code is completed.
2.3.3. Duress Code
z
Duress Code can also be used to
arm/disarm the system. However, when
this code is used for accessing the system,
the Control Panel will report a secret
Emergency alarm message to the Call
recipient to indicate of a
Duress Situation
in Progress .
z
There is
NO
siren sounding for duress
alarm.
z
Control Panel will play Emergency alarm
voice message for
Voice Reporting . (refer
2.2.1 Telephone Numbers)
z
The Duress Code consists of 4 digits and
is not activated as default by the factory.
To Set Duress Code
Step 1. Use the arrow keys to select Duress
Code and press OK key
E n t e r N e w C o d e
. . . .
Step 2. You can key in your preferred 4-digit
number and then press OK key
R e p e a t N e w C o d e
. . . .
Step 3. You are prompted to re-enter the same
code again and press OK key.
If the code is correct, the screen
returns to
General Setting menu,
setting the Duress code is completed.
To Delete Duress Code
After the DuressCode is programmed, it can be
deactivated/deleted by following the steps
below:
Step 1. To delete programmed Duress code,
select the Duress Code from the Gen.
Setting Menu , then, the screen will
show:
D e l e t e
P i n - C
o d e ( + O k ) ?
Step 2. Press OK key to confirm.
To Edit Duress Code
After the DuressCode is programmed, it can be
edited by following the steps below:
Step 1. To edit programmed Duress code,
select the Duress Code from the Gen.
Setting Menu , then, the screen will
show:
D e l e t e
P i n - C
o d e ( + O k ) ?
Step 2 . Press key, the next screen will ask
you to enter your new Duress code
and repeat it for double confirmation.
Step 3 . Press OK key and editing the Duress
code is completed.