24
P l e a s e a d d
o n e d e v i c e
The message will be displayed for 2
sec. then the screen returns to
Device
+/-
menu. You are requested to add a
detector or Remote Controller first
then you can try programming these
auxiliary devices again.
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
For the following options, whichever option
is selected, when the Control Panel
transmits the signal, all added sirens will
simultaneously received the signal and all
will acted accordingly
Siren Tamp.On, Siren Tamp.Off
The Outdoor Siren BX-8 tamper switch can
be enabled and disabled remotely. This is
used especially when replacing siren
battery.
z
Disable the Siren tamper switch by
selecting
Siren Tamp.Off
and press
OK
key. All added sirens will
temporarity lose their Tamper
Protection simultanously
z
Enable the Siren tamper switch by
selecting
Siren Tamp.On
and press
OK
key. All added sirens will be
enabled with the Tamper protection
simultanously.
<
<
N
N
O
O
T
T
E
E
>
>
)
The Siren tamper disable will
automatically revert to
On
after about
an hour if not switched back.
Confirm On, Confirm Off
Both the Outdoor Siren BX-8 can be
enabled for arming and disarming
confirmation where beeps are emitted
from the Siren to validate that the system
has been armed and disarmed.
z
Disable the Siren Confirmation by
selecting
Confirmation Off
and press
OK
key.
z
Enable the Siren Confirmation by
selecting
Confirmation On
and press
OK
key.
Entry Snd On, Entry Snd Off
The Outdoor Siren BX-8 can be enabled
or disabled from sounding the Entry Delay
warning beeps.
z
Disable the Siren Entry Sound by
selecting
Entry Snd Off
and press
OK
key.
z
Enable the Siren Entry Sound by
selecting
Entry Snd On
and press
OK
key.
Receiver 1, Receiver 2
2 additional Universal Receivers can be
added to the system.
Step 1
. Put Universal Receivers into learn
mode (Refer to their individual
Operational Manual).
Step 2
. Move the cursor to the position
Receiver 1
Step 3
. Press
OK
key.
Step 4
. The Control Panel will then sound a
long beep and transmit Learning code
to UR#1 simultaneously. The UR
status LED lights up for 3 seconds.
<
<
N
N
O
O
T
T
E
E
>
>
)
If Receiver 2 is also to be added to the
system, proceed to the following steps:
Step 5
. Move the cursor to the position
Receiver 2
.
Step 6
. Press
OK
key.
Step 7
. The Control Panel will then sound a
long beep and transmit Learning code
to UR#2 simultaneously. The UR
status LED lights up for 3 seconds.
Step 8
. Remember to put these Universal
Receivers out of Learn mode. Adding
them into the system is completed.
Summary of Contents for CTC-1132
Page 1: ...Installation Programming Operating D D 29 APR 2009...
Page 2: ......
