Gardsman CTC-1052, User Manual, Page: 8 / 46

5
3. System Configuration
3.1. Entering Programming
Mode
Two CTC-1052 programming modes are
available: Local Programming Mode and
Remote Programming Mode.
<NOTE>

GPRS/3G/LTE module will be powered
down when in Programming Mode.
When AC Power resumes or when
exits
from Programming Mode,
GPRS/3G/LTE module will be powered
on again.
3.1.1. Local Programming Mode
From Idle mode, follow the steps below to enter
Local Programming mode.
Step 1. Plug in the telephone set into LOCAL
PROGRAMMING input located on the
rear side of CTC-1052.
Step 2. Pick up the handset.
RED LED lights up.
Step 3. Enter default ACCESS CODE, 1111
followed by # .
Step 4. CTC-1052 will emit 2 short beeps and
the red LED starts to flash, indicating it
is in
Programming Mode.
Step 5. Proceed to program system by
referring to the Commands in section
3.2 Programming Your 1052
.
<NOTE>

Local programming is prohibited when
AC Power fails.

The first digit of Access Code must be
entered within 15 seconds, otherwise
CTC-1052 will exit automatically.

Failure to enter the correct Access
Code within 2 minutes will cause CTC-
1052 to exit the Programming mode
automatically.

To exit Programming mode, enter 99
followed by # , or place the handset on
hook, or disconnect the Programming
telephone set.
3.1.2. CTC-835 Programmer
CTC-835 is a powerful programming tool (sold
separetely) that features a built-in keypad and
LCD display to help you to program the medical
alarm panels effeciently and conveniently. It
also features
Once-for-All Uploading , which
allows you program on a computer via the
supplied
Pilot software and you can then upload
all the settings to the medical alarm panel
simultaneously with a single mouse click.
For detailed usages, please refer to the
Operation Manual of CTC-835 Programmer.
3.1.3. Remote Programming Mode
To allow Remote Programming, there are two
options for CTC-1052 to answer the incoming
calls.
(1) Auto Answering by ring count
(2) Dial in twice (Ring Count disable)
The two options are set by Command #41.
Please refer to
Command 41 under section 3.2
Programming Your 1052 .
3.1.3.1. Auto Answering by Ring Count
By using Command 41, you can set the number
of rings for CTC-1052 to answer (
00-Rings is
set as factory default).
Step 1. Dial CTC-1052 and wait for CTC-1052
to answer.
Step 2. Enter 1111 (default 4-digit Access
Code) followed by #, via the phone set.
Step 3. CTC-1052 will respond with two quick
beeps to indicate it is ready for Remote
Programming. The RED LED will flash
as a visual indication.
Step 4. You are now in Programming Mode.
Proceed to program by referring to the
Command
under section 3.2
Programming Your 1052.
3.1.3.2. Dial in Twice (Ring Count Disable)
As 00 is set in Command 41 by default, it means
CTC-1052 is disabled to auto answer the
incoming calls by ring count. If Remote
programming is required, you will need to call
CTC-1052 twice.