Gardsman CTC-1052, User Manual, Page: 7 / 46

4
2. Learn-in the Devices
There are two methods to learn in devices:
command learning and local learning . The
system can learn a total of 20 sensors.
2.1. Command Learning
Command Learning :
1. The user can use Commands 91-94 to
learn devices into the system.
2. Command 93 is designed to learn in
devices for silent reporting, including
WTR, Fall Sensor, or Panic Button.
3. Command 93 & 94 is designed to learn
in the following devices and sensors.

PIR Sensor ----- PIR

Smoke Detector ---- SD

Carbon Monoxide Detector---- CO

Fixed Panic Button ---- PB

Wrist Transmitter ---- WTR

Pendant Transmitter ---- WTR

Water Sensor ---- WS

Fall Sensor ---- FS
2.2. Local Learning
Local Learning :
The user can also use the local learning
method to learn in all devices.
1. When the device is learnt in for the first
time, voice prompt will prompt the
device/sensor name and “learned.”
2. Within 3 minutes after exiting learning
mode, the control panel will emit 1 long
beep everytime it receives a test code (from
any device).
3. Local Learning Mode cannot remove
devices or sensors.
To enter Local Learning Mode:
1. Press and hold the Green Reset Button of
the CTC-1052. When pressed, the CTC-
1052 will emit one beep sound initially, and
then will emit a double beep on the 6
th
second.
2. Release the Green Reset Button at the
voice prompt “Release the Green button,
Ready to learn sensor.” CTC-1052 is now
in learning mode and the Red LED will start
flashing.
3. Press the (Learn) button on the device or
sensor. Voice Prompt: “(Name of Sensor)
learned.”
4. If no action within 10 seconds after “Ready
to learn sensor” prompt, CTC-1052 will
prompt “Press sensor button.” This prompt
will repeat two times if no action.
5. If no action after second “Press sensor
button” prompt, CTC-1052 will prompt
“Press Green button to exit learning mode.”
This prompt will be repeated three times if
no action continutes.
6. If no action after 5 minutes, the CTC-1052
will automatically exit Local Learning Mode
and return to idle mode. Voice Prompt: “We
are now in Normal Operation Mode.”
2.3. Learn-In Device using
Device ID

If sensor device ID is given (please consult
the supplier), the users can learn the device
into the Control Panel using device ID.

User can use SMS commands or the
programming tool SMS iWizard (sold
separately) to learn devices using device ID.

Please refer to the table
CTC-1052 SMS
Programming Command Table
or the SMS
iWizard operation manual on how to learn in
devices into different zones using device ID.