Gardena ErgoJet 3000, Operating Instructions Manual, Page: 26 / 356

WARNING:
If the unit becomes clogged, stop the unit and unplug the
extension cord. Wait until the impeller has completely stopped turning,
then remove the vacuum tubes. Carefully reach into the vacuum opening
and clear out the clogged debris.
This will reduce possible personal injury from the impeller.
Removing an object from the
air intake: 1. Remove the vacuum tubes.
2. Carefully reach into the vacuum opening and clear out the air
intake area. Clear all debris from impeller.
3. Inspect the impeller for cracks. If cracked or damaged,
do not use the unit. Have parts replaced by your authorized
service dealer. Do not attempt to replace them yourself.
7. Troubleshooting
WARNING:
Always stop unit and unplug the extension cord before
performing all of the recommended remedies below except remedies
that require unit to be operating.
The motor must be stopped and the impeller blades no longer turning to
avoid serious injury from the rotating blades.
Problem Possible cause Remedy
Unit fails to operate. 1. Switch in the OFF (0) position. 1. Slide switch to
ON (I) position.
2. Extension cord disconnected. 2. Reconnect extension cord.
3. Circuit breaker tripped,
or fuse blown.
3. Reset circuit breaker or
fuse.
4. Blower tube, elbow tube,
and/or vacuum tube not
installed correctly.
4.Check tube installation.
5. Collection bag is full. 5. Empty collection bag.
6. Mechanical failure. 6. Contact your authorized
service d ealer.
Unit vibrates abnormally. 1. Mechanical failure. 1. Contact your authorized
service d ealer.
Impeller will not
turn freely. 1. Debris in air intake area. 1. Clean unit. Remove any
debris.
2. Mechanical failure. 2. Contact your authorized
service dealer.
For any other malfunctions, please contact the GARDENA
service department. Repairs must be carried out by GARDENA
service departments or specialist dealers authorised by
GARDENA.
26
GB
9332-20.960.01.indd 26 04.01.12 07:47