23
7100 Series Installation/Operating Manual —
P/N 9000-0447:J 08/28/08
Installation
7100-NetSOLO Cabinet Installation
2.3.1 7100-NetSOLO Backbox Installation
1.
To prepare the mounting site, pre-drill four (4), #10 screws, using the dimensions shown in the
figure below. Use four (4), #10 screws.
2.
Secure with two (2), #10 screws in the two-hole mounting pattern as shown in Locations 1 and
2 of the figure below.
3.
Set the backbox over the top, two-hole mounting pattern, and hang the backbox over the two
screw heads.
4.
Insert and secure two (2), #10 screws in the two-hole mounting patterns as shown in Locations
3 and 4 of the Figure 2.3.2.
Figure 2.3.2 7100-NetSOLO Backbox Dimensions
NOTE:
If the fasteners are anchored to a wallboard, use #10 wall anchors. Mountings to
concrete walls should be backed by plywood to insulate the equipment from possible
condensation.
NOTE:
Add knockouts to the left and right side of the rear panel of the backbox. Do not add
knockouts in the center or top of the backbox. To add larger knockouts, increase the size of the
existing knockouts.
1.70"
BACKBOX TOP
BACKBOX
19.26"
16.38"
4.00"
1.50"
16.00"
1.35"
16.69"
19.38"
8.00"
4.00"
1.50"
2.25"
BACKBOX SIDE
