Galvanic Applied Sciences USA, Inc.
101 Billerica Ave, Bldg. 5, Suite 104.
North Billerica, MA. 01862
Tel: 978-848-2701
Fax: 978-848-2713
Email: [email protected]
5
Safety instructions
Pay attention to the following general safety instructions during use and operation of the system.
Ignoring these instructions or special warnings inside of this manual can damage the sensor, cause
inaccurate measurements, and possibly result in unsafe installations.
Galvanic Applied Sciences will
not take any responsibility for consequences arising from ignoring the safety instructions and warnings.
Electrical installation
Qualified technical personnel must install the electrical installation of the system.
Hazardous area
DO NOT INSTALL the system in hazardous area without the optional Ex-proof equipment.
Operation of non Ex- proof systems in hazardous area will cause a high risk.
Using the system in hazardous areas (Ex Zone I / Ex Zone II) will only be safe with the
installation of the optional special Ex-proof designs including all required certifications
.
Maintenance
Always disconnect the instrument from power during maintenance, replacement of components,
installation of additional components or any other operations at the open instrument.
Only qualified technical personnel must perform this work.
Operating the instrument with open enclosure
Only qualified technical personnel should operate the instrument when the enclosure is open
(e.g. during calibration procedure). Be careful that no moisture enters the enclosure.
Some components inside the instrument are energized with voltages, which can cause lethal shocks
in case of contact. Be careful during installation, handling and operation of the instrument.
Improper installation / operation of the system
Warranty is void if the system is installed improperly, handled improperly, used outside of the technical
specifications (of the instrument), or damaged by gross negligence.
