Galcon Galileo, Setup

Page: 58 / 66

58
Controller
Hardware and Accessories Setup and Utility
Switch 3 - Is used to put the unit into test mode and offers 3 extra system ID switches.
Switch 3.1 – Reserved for future use.
Switches 3.2, 3.2 and 3.4 have the following use:
For normal operation with GALILEO W/2000 set switches 3.2, 3.3 and 3.4 to “Off”
For testing outputs 1 and 2 in a switching loop of 30 seconds set switches 3.2 to “On”, 3.3 to
“Off” and 3.4 to “On”.
Switches 3.5, 3.6 and 3.7 are extra system I.D.’s
Switch 3.8 – Reserved for future use.
Jumper JP1 is used to select the radio that is being used by the system.
If a Motorola GM 340 mobile radio is to
be used, the jumper should be in this
position.
If a Motorola GM 350 mobile radio is to
be used, the jumper should be between
the central pin and the top pin.
The GALILEO W/2000 Controller
Define the bus slot number into which the TX interface card is to be installed and program the
controller for a Radio RTU under main menu 7 (Set-up) and sub menu 4 (I/O Cards).
Activate the number of radio RTU’s to be used by the system under main menu 6 (Technical
Info.) and sub menu 2 (RTU Units).
NOTE!!! If a RTU fault is generated by the system, deactivate RTU faults in the alarm menu.
Appendix 2: Radio Remote Terminal Units (RRTU)