Galcon Galileo, Setup

Page: 35 / 66

35
Controller
Hardware and Accessories Setup and Utility
own identification number. Each RTU will normally have more then one I/O element of
each kind, and at times – more then one kind of element (Inputs, Outputs, Sensors).
The reference to an I/O element as far as the controller’s software is concerned, is a kind
of coordination table. It can be described as:
Valve number n = output number X in unit
number Y in channel type Z.
In the controller’s I/O connection table, Z is represented as a prefix digit, A dot as a divider,
and a four digit number. When the output is local – the prefix will remain Zero and the
suffix is just the same as described
above – a serial number according
to the I/O modules of the controller.
When the output is operated via
one of the RTU types – you should
use the prefix 1 or 2 as explained
above, the 3 digits on the right of
the dot will be a decimal value of
the binary code of the unit where
the component is installed, and the
rightmost digit will be the number of
the output in the RTU.
Technician code
Note: Before applying any RTU layout – please read the appropriate chapter in this
manual
particularly noting the paragraph dealing with skipping codes when using CRTU 4-
8-4
Outputs and discrete inputs setup .6
Cannel type:
0 = Local
1 = Single cable RTU
2 = Radio RTU
In case of RTU (if prefix either 1 or
2) – the PIN code (decimal) of the
RTU where the device connected.
The output number within the
RTU.
Valid values: 1 and 2 only
In case of local connection (if prefix
is 0) – the serial number of the
output is sequential.
{
{
{
{
Controllers used with operating system 2.17 or higher have a blocking
code to protect the definition segments from unauthorized modification.
Access the key through menu <74> and type 0007 E n t e r E n t e r .
The entire menu is opened until relocked (same address) 0000
E n t e r E n t e r
or after
leaving the keyboard untouched for 30 minutes.